Wiring Diagram

WhisperGreen Select Wiring Configurations 1) Manual Control Wiring Diagram (ON/OFF or Boost from Low Speed to High Speed) •

Connect red Signal Wires directly to Wall Switch All modules are functional when installed

• •

DO NOT connect Signal Wires to Power

2) Automatic Control Wiring Diagram (Wire direct to power supply) • •

Signal Wires must be capped separately Must have Motion or Condensation module for Fan to Operate in High Speed

•

DO NOT connect Signal Wires to Power

3) Basic Wiring Diagram (ON/OFF for Single Speed) •

Signal Wires must be capped separately

•

No Modules will function when fan is switched off

WIRING METHOD 1 – For MANUAL CONTROL & All Plug & Play modules Power Fan

NOTE: This wiring method for MANUAL CONTROL of the fan. Red wires loop to Single Pole switch.

WIRING METHOD 2 – For AUTOMATIC CONTROL only (All Plug & Play Modules) Power

Fan

NOTE: This wiring method is for AUTOMATIC CONTROL of the fan (motion sensor/humidity control ONLY). No manual control. Red wires must be capped separately.

WIRING METHOD 3 – For On/Off Operation Only (No plug in modules) Power Fan

NOTE: This wiring method may cause Plug & Play modules to not function correctly. Red wires must be capped separately